The light-duty indoor model uses lighter fabric with the same weighted ground seal as CoverSeal’s outdoor covers. It is intended for garages, barns and carports, where dust and rodent access are the main concerns. Choose a heavy-duty outdoor model for prolonged exposure to outdoor weather.

Yes. The lighter indoor model is a practical choice for frequently covering and uncovering a garaged vehicle. Start with a clean, dry vehicle and a clean cover, and lift the fabric into place rather than dragging it across the paint.

Check the vehicle for signs of rodents or nesting first. Identify the front and rear of the cover, then drape it from front to back. Pull the weighted apron down so it contacts the ground around the vehicle, and check for perimeter gaps. Lift the cover during fitting and removal instead of dragging it over the paint.

Dust or grit trapped between any cover and the paint can leave fine marks. Cover only a clean, dry vehicle with a clean cover, lift it on and off rather than dragging it, and shake debris from the inside before storing it. The weighted design makes careful handling especially important.

The bottom apron is waterproof, but the light-duty indoor cover is not intended for outdoor weather protection. Cover a dry vehicle in a sheltered storage area. On CoverSeal’s outdoor models, the fabric is highly water-resistant rather than fully waterproof, and ventilation pockets help reduce condensation.

Remove food, paper and other rodent attractants, clean the interior, and check for existing nesting before covering. Position the weighted apron against the floor around the vehicle. A ground-contact cover can help reduce rodent access, but it does not guarantee exclusion; continue checking the vehicle during storage.

CoverSeal’s warranty covers defects in materials and workmanship for one year from purchase. It does not cover damage from sharp edges, antennas, accidents, extreme weather or ordinary wear.

Unused covers can be returned within 30 days of delivery.

CoverSeal’s patented weighted apron rests on the ground around the vehicle, helping reduce perimeter gaps rodents may use to reach the engine bay, wiring or hoses. It can help reduce rodent access, but it does not guarantee exclusion—determined rodents can chew fabric. Check for nesting before covering the vehicle. This light-duty indoor cover is intended for garages, barns and carports to help with dust and rodent-risk reduction, not outdoor weather protection.

Yes. The weighted bottom apron is designed to rest on the ground and is made from waterproof tarp material more than 10 mil thick, suitable for concrete, asphalt, gravel or grass. The apron itself is waterproof; this light-duty indoor cover is intended for indoor or sheltered use, not outdoor weather protection.

The loose fit lets the cover drape to the ground so its weighted apron can help reduce perimeter gaps. It is designed to provide a ground-contact barrier for indoor storage rather than a custom-fit silhouette. This light-duty model is intended for garages, barns and carports, not outdoor weather exposure.

This cover is available in silver. The fabric reflects about 90% of sunlight, helping reduce heat and sun-related fading or damage and helping extend the fabric’s life. This light-duty model is intended for indoor or sheltered storage, not outdoor weather protection.

Side-mirror pockets are not needed to help hold the cover in place. The weighted apron rests around the vehicle perimeter and helps reduce gaps without relying on mirror pockets. Check for existing rodents or nesting before covering.